Diesel Home Page

Diesel Service Technology Required Tool Set
The staff at PCC strongly recommends purchasing high quality tools which have a lifetime guarantee. Students have an excellent opportunity to purchase tools at a substantial discount through many different vendors which support the Diesel Program. It is recommended that students contact a Diesel Service Technology Instructor for guidance in the purchasing of the required tool set. Information on purchasing tools can be obtained by calling the diesel shop at 503-614-7210. The Tool set listed below is adequate to accomplish the work required of the students during class and it will enable the students to accomplish the work required of them when they first are employed. It should be understood that technicians must continue to build their tool complement throughout their career.

3/8" Socket Set	Universal	3/8"
	Speed Handle	3/8"
	Ratchet	3/8"
	Extension	3"
	Extension	6"
	Extension	10"
	Sockets 12 point	5/16" - 13/16"
	Socket rail	3/8"
	Sockets 12 point	10-19 mm
	Socket rail	3/8"
	Hex Key Sockets	2-10 mm
	Socket rail	3/8"
	Hex Key Sockets	1/16" - 3/8"
	Socket rail	3/8"
1/2" Dr. Socket Set	Flex Handle	18"	<top>
	Ratchet	1/2"
	Extension	3"
	Extension	6"
	Sockets 12 point	7/16" - 1 1/4"
	Socket rail	1/2"
	Sockets 6 or 12 point	7/16" - 1 1/4"
	Adapter	3/8" to 1/2"
	Adapter	1/2" to 3/8"
Wrenches	Combination Wrenches	5/16" - 1 1/4"
	Combination Wrenches	10-19 mm
	Offset Open End Wrenches	5/16" - 3/4"
	Adjustable Wrenches	8"
	Adjustable Wrenches	12"
Pliers	Slip Joint Pliers	6"
	Adjustable Locking Pliers	7"
	Water Pump Pliers	9"
	Long Nose Pliers	6"
	Diagonal Wire Cutter	6"
Screwdrivers	Slotted	1/4" x 6"
	Slotted	3/16" x 9"
	Slotted	3/8" x 12"
	Phillips #1	#1 x 3"
	Phillips #2	#2 x 8"
Hammers	Ball Peen Hammer 12 oz.		<top>
	2 lb. Dead Blow Hammer
Air Tools	Impact Gun 1/2" 400 foot lb.
	Blow Gun, OSHA approved
Electrical Tools	Digital Mutli-Meter
	Battery Terminal Cleaner
	Electrical Stripper/Crimper
	Test Light 12 volt
Punches and Chisels	Pin Punch	1/8"
	Pin Punch	1/4"
	Center Punch	3/8"
	Chisel	1/2"
	Starter Punch	3/8"
Miscellaneous	Hacksaw
	Steel Rule	6"
	Gasket Scraper
	Pry Bar	flat type
	Feeler Gauge	.001" - .030"
	Coarse File	10" Mill Bastard File
	Fine File	6" Smooth Flat File
	Telescoping Magnet	4" - 19"
	Safety Glasses with side Shields
	Flashlight
	Ear Muffs
	Tape Measure	12 Foot
	Steel Wire Brush
Tool Storage	One roll around bottom tool chest		<top>